paving stone Cement Form concrete mould
How to use this Pavement Mold to build the pathways:
7 EASY STEPS
1. GETTING STARTED
All you need is:
The PathMate can be used on any relatively flat surface. You will get the best results by clearing any sod and leveling your working surface first. Plan out your job and then set your PathMate where you want to start.
3. MIXING CONCRETE
Each PathMate mould requires one 60 pound bag of concrete. Add 3 quarts of water to the ODJOB mixer (two capfuls),add the bag of pre-mix, seal the lid and roll for 30 seconds. If you require more water, add one-half cup at a time until you have a consistent mix.
4. FILLING THE MOULD
When your concretes is mixed, simply pour directly from the ODJOB mixer into the PathMate cavities. Fill the cavities you want to use and then smooth the surface with a trowel.
5. REMOVING THE MOULD
Let the concrete set for about one minute before removing the mould. Then give the mould a slight shimmy or twist and lift the mould clear of the concrete.
6. FINSHING TOUCHES
After removing the mould, smooth the edges with a trowel. You can create a variety of finishing surfaces with your trowel, or you can sprinkle on some sand to provide texture. If you want to colour the stones, simply add cement dye during the mixing process.
7. FILLING IN
You can sweep sand or soil into the spaces to fill the gaps or to permit grass to grow between the stones.