|Wire Diameter mm
Product Model: 24K carbon fiber heating cable
Working voltage: 220V
Insulation strength: >500 megohms
Product model: 24k
Outer layer protection: high temperature resistant PVC layer
Product specifications: 12.5m per group
Temperature resistance temperature: 280 degrees
Product power: 230w per group
Wire diameter: 5.5mm
|2 roots / group
|3 roots / group
|4 roots / group
|5 roots / group
|6 roots / group
|7 roots / group
|8 roots / group
|9 roots / group
|10 roots / group
|11 roots / group
|12 roots / group
|13 roots / group
|14 roots / group
1.K represents the meaning of thousands?
1K is a thousand silk, 24K is 24 thousand silk (24000) composition
Different K numbers represent different resistorsl
2.The difference between silica gel and Teflon
PTFE/PFA/FEP carbon fiber heating wire
Advantages: Wear, corrosion resistance, no smell
Disadvantages: Relative to the silicone are not soft
Silicone carbon fiber heating wire
Advantages: Resistant to bending, soft
Disadvantages: There is smell
3.What is the resistance per meter?
1K=400Ohm/m, 2K=220Om/m, 3K=133hm/m, 6K=74Ohm/m, 9K=43Ohm/m, 12K=33Ohm/m, 15K=24Om/m, 18K=21Ohm/m, 24K=17Ohm/m, 36K=12Ohm/m, 48K=9Ohm/m
4.How to calculated power
Product power calculation:
The longer the length, the smaller the power of the heating line
The heating wire can not overlap when used! Can not cross!
Cross-over will make the heating line local temperature higher than the melting point of the protective layer, will damage the heating wire!
The normal laying power is 100-160 watts per square. Different areas can be increased or decreased according to the room's own insulation and the type of floor. The installation is very simple, we will guide the installation, the normal laying distance is 12cm.
The carbon fiber heating wires must not cross between each other during installation and should not be touched with each other. After installation, wait until the concrete floor is fully dried and then heat to prevent the floor from being cracked and twisted due to excessive temperature rise. When using the floor heating for a long time, set the minimum temperature first, then slowly heat up for the same reason.