Epoxy Self Levelling Floor Coating Material

Product Overview

Description

EPOX SL 800 is an epoxy resin based, two component, low viscosity, solvent free, self-levelling multi-purpose coating material.

• On concrete and cement based mineral surfaces,


• On medium and heavy wear industrial areas such as factory, storage halls, loading ramps, airplane hangars etc.


• On wet volumes such as hospital, laboratory, industrial kitchens, food, pharmaceutical industries etc.


• On gym centers, carparks, shopping malls as coating material.

• Excellent adhesion performance.


• Solvent free, safely used in interior surfaces.


• Excellent penetration ability due to low viscosity.


• Excellent chemical and mechanical strength.


• Easy to apply.


• Easy to clean.

Content Density Solid Content Shore D Hardness Adhesion Strength Compressive Strength Flexural Strength Abrasion Strength Chemical Resistance     Application/Substrate Temperature Drying Time Pedestrian traffic Light traffic Full curing HS Code

Epoxy resin 1,4 g/cm3 100% 76 (7 days, at 23°C) >1,5 N/mm2 (break off concrete) 60 N/mm2 (28 days at 23°C) 30 N/mm2 (28 days at 23°C) 80 mg (CS17,1 kg, 1000 rpm) High resistant to benzene, cyclohexane, diesel oil, ethylene glycol, glycerin, sodium hydroxide, paraffin and oil. +10°C to +30°C   10 hours (at 30°C) / 13 hours (at 20°C) 1 day (at 30°C) / 2 days (at 20°C) 5 days (at 30°C) / 7 days (at 30°C) 3214.90.00.00.19

Preparation of Substrate

The application surface must be durable, fully cured, sound, dry, clean and clean off all contaminant, rust, oil, dust etc. Surface must be roughened mechanically by blasting, milling or sanding before application. Surface must be primed before the application with appropriate BAUMERK epoxy primers.

Application Method

Component A and B is stirred separately under low speed drill, then epoxy hardener, component B is added into epoxy resin component A and mixed under low speed mixer during 3-4 minutes until homogenous mixture is obtained. Prepared mixture is poured on the primed surface. Notched trowel should be used in order to achieve an aesthetically higher grade of finish. If surface has foam, spiked roller is used in two directions. Make sure that a continuous, pore free coat covers the substrate. Application must be done within 30 minutes. According to weathering conditions, waiting period between the coats must be between 10 to 48 hours. Final curing is done after 7 days. Surface must be protected from water and rain during 24 hours after application. During the application and surface temperature must be between +10°C to +30°C. In rainy and windy days, material must not be applied.

1,50 kg/m²/mm. Recommended application thickness is 1,5-2,5 mm.

A component: 20 kg + B component: 5 kg = 25 kg set

 

12 months in original, unopened package.

Store in dry area between +5°C and +35°C. Protect from heat, freezing and direct sunlight.

Clean tools and equipment with industrial type solvents immediately after use. Dried material can only be removed mechanically.