2FT LED slat light Smart band display easy to mount 20 watts waterproof batten lighting with battery warehouse
Product Description
The Tri-proof batten fixture(SMD) works under normal supply of AC power, IP65 protection,dust-and moisture-proof, impact resistant. Using stainless toggles and stainless steel mounting brackets, easy installation and maintenance.
Application
It widely used in tunnel, Rail-way station,Metro station, Supermarket, stair well, corridor, evacuation passage, especially parking lots.
Metro
Warehouse
Stair well
Evacuation Passage
Parking lots
Features
1.Adopt high-grade Aluminum base and PC cover fitting, good quality seal for better waterproof, high transmittance frost cover(>86%),IP65 protection rate. 2.Surface mounted or hanging installation option. 3.Using high brightness SMD2835 led chips as light source. 4.Adopt high quality LED constant driver. 5.Available in 2ft 18-20W, 4 ft 36-40W and 5ft 44-50W. 6.Available working at half-power mode 2ft 9W, 4 ft 18W and 5ft 22W(set on driver). 7.Approved CE ROHS SAA and C-tick(RCM). 8.years warranty.
Certifications
SAA
CE
RoHS
C-Tick
Installation
1.Open the package; take out the accessory metal buckle. 2.Check the fixture and make sure the cover clips fixed well , if necessary,open the cover and check inside. 3.Tack two plastic studs on the ceiling/wall and Put the metal buckle on the wall with a screw. 4.Install the fixture on the wall with buckles. 5.Open the cover and let main power wires go through the Gland and connect wires to inside terminal block as follows(for bulk order without plug)Connect main power live line (L-brown) to “L” , L--L; Connect main power Earth (L-Yellow&Green) to “Earth”, Earth--Earth;Connect main power neutral line(N-blue) to “N”, N--N.
Maintenance
1. In order to extend lifetime of the product and more safe operation, please keep it clean, maintenance and don’t using it in more than 40 Celsius or less than minus -20 degree environment and avoiding 7x24h full power light on. 2. While cleaning the lamp, please use the soft cloth with soap water and wring it, then try to sweep. 3. If there are any doubts or problems while you are installing, please contact your supplier or manufacturer.
Cautions
1. Before installation, please make sure there is no AC power connected. 2. For indoor and outdoor use. 3. Please notice that don’t use any objectives to cover the lamp. 4. Maintenance should only be done by a professional technician.