Product introduction: The heating rod adopts dual LED display to set the problem and water temperature, and has the functions of dual probe temperature protection, away water power outage protection and so on.
1. The child lock function needs to press the middle setting button of the controller for 3 seconds to set the temperature and prevent accidental touch to adjust the temperature.
2. Press the setting key for 3 seconds, set the temperature flashing, and then press the setting key to select the left and right sides, and heat both sides at the same time.
3, power failure memory function, the product will automatically remember the set temperature at the last shutdown.
4, built-in over-temperature protection system, when the water level exceeds 34 degrees Celsius, the LED screen will display EE, and flash reminder.
5, built-in away from the water power off function, when the heating rod leaves the water surface, the LED screen will display ER, and constantly flash reminder, while the heating rod will be powered off, stop heating.
6. When the heating rod starts to heat, the red light LED is on, the green light LED is off, the red light LED is off when the heating is stopped, and the green light LED is on.
7. When the actual water temperature drops below the set water temperature, the frequency conversion mode is activated, and the body is output at low power.
Notice:
1. Please use it under the specified voltage conditions, otherwise the product will be damaged.
2. This product is a special heating rod for freshwater aquariums or medium and large fish tanks. Please do not use it for heating in sea water, other corrosive media or other occasions, otherwise it will damage the normal use of this product.
3. Please do not allow non-adults or people with abnormal health to touch or use this product, otherwise it may cause harm to the product or the user.
4. Please do not disassemble this product or any other changes that change the product structure, otherwise it may cause harm to the product or the user.
5. The heating rod of this product must be completely immersed in water for use, otherwise the temperature control will fail and unexpected accidents will occur; the temperature controller cannot be soaked in water. It needs to be hung on the outside of the fish tank or other places where it is out of water.