Epoxy Floor Paint Orange Peel Effect

Product Overview

Description

EPOX FL 700 is an epoxy resin based, two component, low viscosity, solvent free topcoat material that provides orange-peel textured surface.

• On concrete and cement based mineral surfaces,


• On heavy wear industrial areas such as factory, storage halls, loading ramps, airplane hangars etc.


• On wet volumes such as hospital, laboratory, industrial kitchens, food, pharmaceutical industries etc.


• On thermal and hydroelectric power plants,


• On convention centers, carparks, shopping mall floors as non-slipping floor coating material.

• Excellent adhesion performance.


• Solvent free, safely used in interior surfaces.


• Excellent penetration ability.


• Does not sagging on surface because of thixotropic behavior.


• Semi elastic.


• Excellent chemical and mechanical strength.


• Easy to apply.


• Easy to clean.

Content Color Density Shore D Hardness Adhesion Strength Taber Abrasion Strength Chemical Resistance   Application/Substrate Temperature Drying Time Pedestrian traffic Light traffic Full curing HS Code

Epoxy resin Gloss, RAL 7032 and the other RAL colors 1,85 g/cm3 76 (7 days, at 23°C) >1,5 N/mm2 (break off concrete) 80 mg (1 kg CS 10,1000 d) High resistant to benzene, cyclohexane, diesel oil, ethylene glycol, glycerin, sodium hydroxide, paraffin and oil.   +10°C to +30°C   10 hours (at 30°C) / 13 hours (at 20°C) 1 day (at 30°C) / 2 days (at 20°C) 5 days (at 30°C) / 7 days (at 30°C) 3214.90.00.00.19

Preparation of Substrate

The application surface must be durable, fully cured, sound, dry, clean and clean off all contaminant, rust, oil, dust etc. Surface must be roughened mechanically by blasting, milling or sanding before application. Surface must be primed before the application with appropriate BAUMERK epoxy primers.

Application Method

Epoxy hardener, component B is added into epoxy resin component A and mixed under low speed mixer during 3-4 minutes until homogenous mixture is obtained. Prepared mixture is applied on the primed surface by using textured roller. Notched trowel should be used in order to achieve an aesthetically higher grade of finish. If surface has foam, spiked roller is used in two directions. At the last step, textured roller is used to provide even and texture effect. Application must be done within 30 minutes. According to weathering conditions, waiting period between the coats must be between 10 to 48 hours. Final curing is done after 7 days. Surface must be protected from water and rain during 24 hours after application. During the application and surface temperature must be between +10°C to +30°C. In rainy and windy days, material must not be applied.

0,300 – 0,500 kg/m² for each layer. Recommended application thickness is 0,2 mm.

A component: 26 kg + B component: 4 kg = 30kg set

12 months in original, unopened package.

Store in dry area between +5°C and +35°C. Protect from heat, freezing and direct sunlight.

Clean tools and equipment with industrial type solvents immediately after use. Dried material can only be removed mechanically.