MYJG100W 220v or 110v CO2 Laser power supply for 80w 100W engraving and cutting machine

 MYJG 80W CO2 Laser engraving and cutting  machine

MYJG50w-150W new CO2 laser power supply 100W with fault diagnosis, voltage regulator and LED display for CO2 laser tube

MYJG50w to 150W has a LED display, indication its signal instructions and current instructions, which helps the user with fault diagnosis.

With a inside voltage regulator, it can automatically maintain a constant voltage level.

Application

MYJG80W Laser power supply for  40w 50w60w 80w co2 laser glass tube ,Used in  Cutting and Engraving Acrylic, Fabric, Double Color Sheet and Rubber, etc

Main feature

MYJG50-150w  1.power supply for CO2 laser tube adopts zero-current half-bridge soft-switch circuit to ensure the equipment has the advantages of high efficiency and rapid response speed, applying to laser tubes from different factories.

2.Its simple control port is applicable to high/low level signal. TTL level is to control the on/off of the laser with an anomalistic protective switch to check water-flow and ventilation, etc.

3.Adjust the power: Input analog signal(0~5V) or PWM to control the output power.

4.Open power protection in the power supply has these functions: the power supply can work for a short time in the state of open circuit while the case touches the ground well so as to avoid damage to the power supply caused by the laser tube burst.

Aging check before consignment:

Each power supply before selling will go through the aging check:

(1) sustain 10 hours at temperature 60 Degrees Celsius under full-load condition;

(2) 500 times on/off check for 7 seconds.

1. All our item is pass the ISO9001 and CE quality Certification.
2. We are the manufactory of the Co2 Laser Power Supply, and have strict quality control system, so that we can supply the best quality products with lowest prices for our client.
3. Our factory have a professional technical support group for all the item selling. If you need any assistance on your item problem, please do not hesitate to contact us, our technical support will be there to assist you. 
4. Manual testing: Make sure the power supply and laser tube wiring correct firstly, offline the control line and then press the red button TEST to test laser tube out light or not, this method can be simple judgment power supply is working correctly.

Any more required or question please feel free to contact us 

All the items we have in stock , we can ship it out within 1-2 days after confirm  your payment .

We will send it by DHL .EMS  UPS or Fedex TNT . And for a amount of  it , we can also send it by Air transport or by sea ,

All the way depend on Customer's Choose

The power supply will package with sponge in a carton box ,