Trunk car spoiler, rear car lip spoiler

REMARK:

1. Spoiler should be installed in a warm inviornment. Surface tempearture should be between 70-80 degree. Do not install under the sun.

2. Incluede is adhesive double side tape and adhesive tape promoter.

It can withstand heat of up to 180 degree surface temperature. (Slicon Glue high recommended)

3. Do not install it humid, wet, hot or cold conditation. The adhesive on the spoiler will not bond to the surface and will easily come off.

4. Test fit spoiler before installing.

5. Wash and dry surface with the regular soap and water (no window cleaner or windex)

6. For glass, finish off with rubbing alcohol

7. Pre-fit spoiler using masking tape

8. Make a line usinh the masking tape on the center of the spoiler to the center of the roof of the vegicle.

9. Make sure the lines drawn are center to center.

10. Slowly remove the non-stick adhesive film one side at a time while applying pressure to the spoiler. (Continue on the other side)

11. Once the spoiler is spplied completely, use masking tape on both corners to apply pressure for 24-48 hours. Additional masking is highly recommended to pin the spoiler to the surface.

12. Allow 24-48 hours for the adhesive to fully bond to the glass before remoning masking tape.