Best selling items platinum cure liquid silicone plaster moulding mold making rtv 2 liquid silicone rubber

Why did the clients choose our DC Silicone: 

1.Free Sample   

2.Silicone Performance Test   

3.Technical Support   

4.More than 10 years experience of silicone rubber producing.   

5.Relatet products purching assistance  

6.China visiting reception   

7.Factory visiting Reception    

8.New market developing 

9.New products research and development  

10.Engineers Site Instruction

11.DC Silicone Quality Control with Strict Management

Why could the silicone mold be reused only for a few times?

Maybe you will confuse about this question for years. Here we share you some following reasons:

a. Adding too much silicone oil into silicone rubber. Silicone oil is an additive which will destroy the molecular weight of silicone rubber and reduce the tension and tear strength.

b. Adding too much catalyst into the silicone rubber when you make the molds. For the condensation cure(tin catalyst) silicone rubber. we suggest you add no more than 2% of catalyst. If you 1add too much catalyst, the operation time will be too fast to operate ,which will also reduce the tension and tear strength.

c. Using the silicon rubber with a high hardness to make molds for small sized products with delicate and intricate designs and the silicon rubber with a low hardness to makes molds for large sized products with simple designs. 

Why does the silicone mold get burnt out?

The silicone mold get burnt out because you have left out the important notes when using unsaturated resin materials to produce your products. The unsaturated resin produces great heat when added the curing agent. So you must demould the product within 3 minutes to avoid this problem.

Our DC silicone rubber has add a special material which can resistant high temperature to make the resin molds. Help our customer avoid this problem.  

Why does the silicone mould appear to be dry outside but wet inside?

Because molding silicone rubber is a kind of condensation silicone rubber, which get solidified after absorbing moisture from the air. In order to provide a significant shelf-life for the silicon rubber, we will dry out the water in the silicon rubber.

Solution: Add 0.05% water into the silicon rubber and Stir over a low speed briefly when you use it. 

Why is the tear strength of the silicone mold weak? 

There has three resons:

Firstly:In order to reduce the viscosity of silicone rubber and pursue a good quality, you may add a lot of silicone oil into the silicon rubber when making molds. In fact, it might have just the opposite effect. The tension and the tear strength will be reduced badly with the addition of silicon oil. And the silicon molds will be in a weak and flimsy manner.

Sencondly:you may add too much catalyst into the silicone rubber,we suggest customers add catalyst no more than 5%,2%will be perfect.

Thirdly:you may use the silicone mold too early after it finished.we suggest the customer begin using the molds after 24 hours. whatsmore,it will be better if you can make a outmold to protect the silicone mold.

Why is the silicon mold oily? 

The molding silicone rubber itself doesn’t contain any oil, so it won’t be oily. If the mold is oily, it may be because of two resons:

1.you add the compound silicone oil( the compound of silicon oil and white oil). The white oil is not silicon oil but a kind of petrochemicals.

2.Your supplier add to much silicone oil when they producing silicone rubber or reducing the hardness of silicone rubber.