PT-10 1008 Wireless product TDM over IP/E1 over IP converter
Brief Introduction PT-10 100X Wireless product TDM over IP/E1 over IP converter will transmit E1 signal through IP channel, the IP channel can be the existing wired Ethernet channel or wireless Ethernet bridge channel. TDMoIP with 8 E1,4FE, 1 SFP optical ,TDM over IP converteradopts UDP format, which supports inner transmission in Ethernet network, and also supports route exchange transmission among network segments. The transmitted E1 can be framed or un-framed format, the E1 interface of the same TDM over IP equipment can be connected with the different remote TDM over IP equipment.
Main Features
1
TDMoIP e1 ethernet converter Providing up to 8 E1 interfaces;
2
Providing 4 ETH interfaces, herein 2 ETH interfaces are uplink interfaces, and the other 2 ETH interfaces are downlinkservice interfaces;
3
Providing OpticalETH uplink interface;
4
Having the high transmission efficiency, and the transmission delay can be adjusted;
5
Supporting point to point, point to multi-point transmission;
6
Supporting E1 framed, unframed setting;
7
Supporting E1 loss alarm indication;
8
Adopting UDP encapsulation, and supporting different types of Ethernet transmission channels;
The equipment firmware and software supports remote update function;
13
Dual powerprotection, support AC220V or DC-48V(optional).
Typical applications
1.Point to point network
2.Point to multipoint network
Certifications
company show
Photel has the design ability in the equipment of SDH, PDH, PBX, IPPBX, PCM, TDMOIP, HDSL...
1, for the SDH, we had the tech of STM-1 to STM-64 in hand, so we can modify any function to follow the customer needed;
2, for PDH, the uplink optical rate can be 150M or 1.25G, the number of E1 can be 1-16, the ethernet can be FE and GE;
3, for PBX, our PBX can support the protocols of SS7, PRI, V5, R2, it can work as a central switch in the telecom network, it can translate different protocol each other, for eaxmple SS7 to PRI;
4, for IPPBX, we can have IPPBX function in our PBX, we only need to configure one or more IPS card in our PBX to have IPPBX function, IP phone can communicate with analogue phone by dialling;
5. for PCM, we have enough experience in PCM for any customer;
6, for TDMOIP, we have the tech of TDMOIP for 1 to 16 E1s, we have done this solution in FPGA to reduce the cost and easy in components buying;
7, for HDSL, our HDSL is in low cost design, and have good ferformance.
