Режущая проволока из молибденовой проволоки бренд JinFenLv режущая алюминиевая латунная 0 20 мм 2000 м

Описание и отзывы

Характеристики

Features and Instructions:

1. Product features 

 1. This product has high tensile strength and high toughness .  It is not easy to break when you want to use and find the brass wire to be knotted . The above two indexes exceed the standard of molybdenum wire stipulated by national standard . 

  2. Small elongation  .   Molybdenum wire is 3%-5%  ;  JinFenLv brass wire is less than 2% . 

  3. Has good straightness ( it will pop out automatically when pulling out the wire from the spool , and pay attention to mess up the wire  when  the wire  is installed on the machine .)  and is not easy to tie the knot  . 

2. Product instructions 

    1. In traditional machine tools , direct use can solve the problems encountered in cutting conductive block and all processing .

    2. Direct use of products, the processing efficiency is same as molybdenum wire 's one  . If you can find the best machining state of the machine and how to use the JinFenLv brass wire, the machining efficiency can be much greater than molybdenum wire 's . In the processing of 60 thick steel pieces, its processing current can reach 4A, can be used for more than 24 hours, the length of wire is more than 350 meters, at this time the processing efficiency can reach 5000 square mm to 6000 square mm per hour.

3. Low elongation, no need to tighten the wire in use after the wire is installed, if have machine with unilateral loose wire , it can be used by hanging the  pulley .

4. The finish is the same as molybdenum wire. Due to the quality of aluminum, different grades of aluminum and different thicknesses of aluminum will lead to different discharge gaps when using different processing parameters.

So before processing high-precision aluminum parts, the test piece should be used for processing first to find out the specific discharge gap before processing.

5. Please remove the conductive block before use, because the imprint is not easy to find, and the position of the wire is not correct, it will cause the phenomenon of wire jamming and wire breakage. After removing the conductive block, normal processing will not be affected

This product can process any kind of material, the best state is to process aluminum.