Новый LQ084V1DG22 Для sharp TFT 8,4 дюймов 640*480 ЖК-дисплей
100,00 $
Сохранить в закладки 1600843536348:
Fault phenomenon | Causes | resolvent |
2. The water level is too low and the pump leaks out of the water surface 3. The motor does not rotate 4. The impeller is stuck or worn | 1. Remove the sundries 2. Adjust the depth of water pump 3. Check the power supply voltage, power line connector and starting switch 4. Adjust the two connectors at will, adjust the steering direction, remove the debris or replace the impeller | |
Unit heating Stop and turn (protection start switch starts) | 1. The power supply voltage is too low 2. The power lead is too thin 3. It is used in large flow and low lift area 4. Seal damage and water inflow | 1. Adjust the voltage 2. Replace the wire 3. Adjust to rated head 4. Adjust or replace the drying motor and seal |
Excessive noise and vibration | 1. Shaft bending 2. Bearing wear 3. The connecting bolt is loose | 1. Straighten the shaft 2. Replace the bearing 3. Tighten the bolts |
Новинки товаров от производителей по оптовым ценам











