Biaoyuan самовыравнивающийся подстилающего слоя крытый уравнитель

Описание и отзывы

Характеристики

BiaoYuan Self-Leveling Underlayment Indoor Leveler

BiaoYuan Self levelling compound for use on concrete, sand/cement screeds and unglazed ceramic tiles

1):Protein-free, suitable for hygiene and food preparation areas
2):Smooths and levels up to 15mm thickness
3):Trowels to a feather edge
4):For interior use only
5):Not suitable for underfloor heating systems

Features and Benefits:

a.High liquidity, precise leveling automatic.

b.Fast setting and early strength, improve the construction efficiency.

c.Low consistency and easy construction.

d.Apply to heating floor.

E:Improve the lower layers intensity, avoiding cracking.

b. Connection between the new and old concrete: used for the reinforcement of construction joints and beam column, reconstruction of old foundation, able to improve shear strength by 3 times.

c. Smooth base course plasterer: replace the smooth concrete surface process of soda-wash oil removal and manual roughing, able to improve bonding force over 6 times.

d. Brick plate paving: interface coating  or paving block board directly after processed into high bonding force mortar, and available to paste new brick on an old brick.

e. Concrete repair and surface protection: used for surface protection of concrete and steel bar, to prevent deterioration and corrosion.

f. Oil pollution, sugaring base course treatment: coating and do plaster processing directly for the dusting and bit oil pollution base course.

g. Waterproof and moisture-proof, anti-corrosion: available to construct on damp base course, can be used as the moist insulation layer of oily coating, bonding firmly with polyurethane coating.

Construction method :
1.The substrate must be clean, dry firm and no any residue, then use Xindadi special interface agent to paint the base plane.
2. After about 2-6 hours, mixed with water before construction, be sure to strictly self-leveling cement: water25:6 ~ 6.5kg mixed. First 6 ~ 6.5kg of water into the bucket, then pour the product side down while stirring until a homogeneous mixture, lay up 1 minute, then stir once again briefly.
3. Pour the mixture into the construction area, a zigzag rake to move to a desired uniform thickness (thickness constructability 1-4mm).Before initial setting, use defoaming roller to exclude air which mixed in before.

Notice:
1. No excess water or it may decrease the compressive strength.
2. No strong wind and sun within 24 hours after construction.