Сохранить в закладки 62525316064:
ETFE Pellets LC360
We supply ETFE pellets with three series of 12 products in 7 colors: injection, extrusion, and mould pressing.
Technical Index
Item | Unit | Test Results | |
Specific Gravity | g/cm3 | 1.73-1.79 | |
Melting Point | ℃ | ≤240 | |
Melting Flow Rate | / | 6-25 | |
Tensile Strength | MPa | ≥30 | |
Breaking Extension | % | ≥200 | |
Compression strength | % | 11 | |
Rockwell Hardness | / | 60 | |
Coefficient of dynamic friction | / | 0.4 | |
Maximal Temperature of Continuous Work | ℃ | 180 | |
Heat deflection temperature | ℃ (1.82 MPa) | 74 | |
Coefficient of linear expansion
| ×105 (K-1) | 9.0-9.3 | |
Volume Resistivity |
| >1017 | |
AC Kv | 3.2mm | 16 | |
Relative dielectric constant | 1kHz | 2.4-2.6 | |
Dielectric loss angle tangent | X106Hz | <0.0005 |
Main Application
These products are mainly used in acid-and alkali-resistant plastic injection parts, extrusion wires and cables, lining, spraying, and blow molding.
Precautions
When dealing with ETFE pellet for deep processing, operators must strictly control processing technic. Processing temperature should not be kept no more than 350degree. Wear protective cloth and mask to avoid potential safety hazards, such as inhalation of dust and toxic gas, or hurt by high temperature. The workplace should be tidy and ventilated. Product waste must be handled properly following local laws and regulations.
Storage & Transportation
The product should be stored in cool ventilated place and away from source and heat source. It should also be prevented against moisture and sunshine, kept in upright position and handled with great care.
Once opened, unused product should be repacked to avoid any dust or contamination.
Новинки товаров от производителей по оптовым ценам