Standard DMX512 Control 6CH DMX Controller for RGB LED Strip

SUMMARIZE:

Thank you for using DMX512 Decoder series.It adopts the advanced micro-computer control technology, it converts the DMX-512/1990 standard digital signal adopted widely in international to the analog control signal.Output 1~6 Channels for option and each channel able to achieve 256 levels of brightness controlling,and also it can be used as the connector of PC digital-light controller and analog light modulator. It is mainly used for the controlling of buildings & lights applied LED.

Details of 6CH DMX Controller:

1 , Converts Standard DMX512 Signals to PWM Output for Driving 12V or 24V DC LED Lighting.

2 , 256-Levels Brightness . Full-color with Driver Controls.

3 , Power without Flashing . Low Jitter Free.

4 , Output 6 Channels,Single Channel Maximum 6A Output Drive ; Such as Only Output 4 Channels,Each Channel Can Be Up to 10A of Output,Total Output is Less Than 40A.

5 , Can Achieve Asynchronous Color Changes Effect under Working with DMX Master C ontroller,DMX Console or DMX Switch Control.

6 , With the Light Color Selected Mechanism, and Be Able to Control the Light with 1~6 Channels.

7 , Setting the DMX Address Freely by Dip Switch .

8 , Modularizing and Can Be Matched with Different LED Module Neatly.

9 , Customized/3 Year Warranty .

Specification of 6CH DMX Controller:

 

1,Drive output interface is altogether anode drive , two V + interface for input and output, each terminal pass 20Ampere current, 

6 channels OUTPUT- interface. CH1 and CH2, CH3, CH4, CH5, CH6 ,can meet all kinds of full color module and monochrome module and automatically according to the lamps module load adjust output current, each channel maximum current is not  more than 6 amps.

Note: Altogether anode connection full-color module which can be directly and refers to the CH1 and CH2, CH3, CH4, CH5, CH6 line connected to the decoder output interface corresponding foot position; Monochromatic module can be connected to the output of the decoder refers to the interface V + feet, negative line according to the color of the module connected to the decoder any of output interface CH1 or CH2, CH3, CH4,CH5,CH6 a foot position; A few kinds of color of monochromatic module received the same decoder, must will be their positive line to decoder output interface V + feet.

2, With self test procedures, keep all 1-9 dip switch up , all 6CH full output during 3s, then each channel gradient.

3, Built-in Switchable DMX Termination(No.10).

Wiring Diagram:

DMX-512 control signal connection

1, DMX signal cable is made of twisted pair (line), DMX signal includes positive and negative end, in pressure welding DMX signal line plug should pay special attention to polarity.DMX512 controller output signal positive, signal negative, signal ground with DE8239 input interface corresponding connection.

2, DMX5000 output and DE8239's transmission lines can't be over 300 meters.

3, DMX5000 each interface can with not more than 170 pieces of DE8239. Eight output interface. Through the JBLED FLASH light making software and can with computer on line control. Realize infinite contact the DMX lights.

4, When connected 32 pieces of DE8239, DMX signal must add a signal amplifier RE2000 . Cascade can't more than 4 PCS.